Installation Manual
Spring Cable Reel
BEF150 – BEF500
MAL6100-0001a-EN
www.conductix.com
translated document
Page 44 of 54
9.4
Changing the direction of rotation
9.4.1
Series connection
Spring designation, e.g.: 2DH (T) H or 2UA (T)H [H for series connection]
BEF185 – BEF500
Fig. 29 BEF185 – BEF500 change of rotation direction, series connection with left/right take-off
→
Section 9.3 describes the steps needed for preparation.
→
Loosen the threaded pin [1] of the fastening flange, then pull off the flange [2], V-ring [3] and spacer [4].
→
On the flange side, loosen the hex nuts [10] of the protective housing bolts and the hex nuts [5] of the connection between the
end flange and the reel body.
→
Remove the silicone joint between the end flange and the reel body, then carefully pull off the end flange with its bearing
flange [6].
→
Loosen the threaded pin of the spacer [7] and pull it off the axis.
→
Carefully lift out the protective housing [9, 11].
→
Loosen the threaded pin of the fixed spring nut [8] still on the axis and take it out.
→
Remove the hex nuts [13] of the "dummy" collar from the end flange on the slip ring body side, and use it to seal the open
holes for the protective housing bolts on the end flange on the flange side.
→
Turn the first protective housing by 180° on its spacer bolts, insert it into the freed-up holes in the end flange on the slip ring
body side and tighten it with the hex nuts [10].
→
Turn the other protective housings by 180° with the spring nut screwed in place, then insert them one after the other into the
first protective housing and then each successive one.
→
Turn the final single spring nut [12] by 180° and fasten it to the axis in such a way that the protective housings are one above
the other and have at least 4 to 5 mm of play.
→
Fasten the spacer [7] onto the axis.
→
Insert the end flange [6] onto the axis (with the spacer as stop) and use the hex bolts [5] to fasten it to the reel body.
→
Insert and fasten the spacer [5], V-ring [3] and flange [2].