Installation Manual
Spring Cable Reel
BEF150 – BEF500
MAL6100-0001a-EN
www.conductix.com
translated document
Page 47 of 54
9.4.2
Parallel connection
Spring designation, e.g.: 2D H (T) or 2UA (T)
BEF185 – BEF500
Fig. 31 BEF185 – FEB500 Change of rotation direction, parallel connection
→
Section 9.3 describes the steps needed for preparation.
→
Loosen the threaded pin [1] of the fastening flange, then pull off the flange [2], V-ring [3] and spacer [4].
→
On the flange side, loosen the hex nuts [5] of the parallel bolts and the hex nuts [6] of the connection between the end flange
and the reel body.
→
Remove the silicone joint between the end flange and the reel body.
→
Carefully pull off the end flange with its bearing flange [7].
→
Pull the spacers [8] off the parallel bolts.
→
Carefully lift out the protective housing(s) [9].
→
Turn the protective housing(s) by 180° and place them onto the axis one after the other.
→
Insert spacers onto the parallel bolts.
→
Insert the end flange [7] onto the axis (with the spacer/spring nut as stop) and use the hex bolts to fasten it to the reel body.
→
Insert and fasten the spacer [5], V-ring [3] and flange [2].
→
Secure the threaded pin [1] against loosening.
→
Seal the cuts on the reel with silicone.
→
Connect the reel (see Chapter 7).
WARNING!
Danger of death by electrocution!
→
Earth the device on the earthing connection (PE) of the slip ring body!