Installation Manual
Spring Cable Reel
BEF150 – BEF500
MAL6100-0001a-EN
www.conductix.com
translated document
Page 45 of 54
→
Secure the threaded pin
[
1
]
against loosening.
→
Seal the cuts on the reel with silicone.
→
Connect the reel (see Chapter 7).
WARNING!
Danger of death by electrocution!
→
Earth the device on the earthing connection (PE) of the slip ring body!
BEF150
Fig. 30 BEF185 Change of rotation direction, series connection with left/right take-off
→
Section 9.3 describes the steps needed for preparation.
→
Loosen the threaded pin [1] of the fastening flange, then pull off the flange [2], V-ring [3] and spacer [4].
→
On the flange side, loosen the cylinder screws [5] of the connection between the end flange and the reel body.
→
Remove the silicone joint between the end flange [6] and the reel body.
→
Carefully pull off the end flange with its bearing flange.
→
Carefully lift out the protective housing and springs [7.8].
CAUTION!
The towing part protective housing is guided by a guide bar inside the reel body and is on the
side where the flange is located.
→
Loosen the threaded pins of the fixed spring nut [9] still on the axis and take them out
→
Turn the towing part protective housing by 180°, insert the guide and push to the empty side of the slip ring body.
→
Turn the other protective housings the fixed spring nut by 180°, then insert them one after the other into the first protective
housing and then each successive one.