Condair Dual 2, Инструкция по установке и эксплуатации

Страница: 53 / 80

53
Following entry of the last digit the opposite message is displayed briefly
to confirm access to the setup level.
Note: If you entered an erroneous code the message “ incorrect code ”
briefly appears on the display, and subsequently you are asked to re­enter
the access code.
Once you have accessed the setup level, the first parameter is displayed
without delay.
Selection of parameters in the setup level
• Use the <
▼
> and <
▲
> keys to select the desired parameter:
<
▼
> : next parameter
<
▲
> : previous parameter
Note: The setup level is an endless loop, i.e. stepping forward from the last
parameter automatically brings up the first parameter again.
Changing parameters
The control unit is in the setup level.
• Press the
<
E
>
key if you wish to change the current setting. The current
setting starts flashing.
• Press the <
▼
> or <
▲
> key to change the setting.
• Confirm the new setting by pressing the < E > key.
Following confirmation of your entry, the opposite message briefly confirms
the new value.
Important! Wait until this message confirms the new setting before access -
ing the next parameter. Otherwise, the modified setting will not be stored.
Note: If you press the < E > key to confirm the current setting without modi­
fication, the opposite message is displayed briefly.
Quitting the setup level
Proceed as follows to escape from the setup level:
• Press the < M > key.
The control unit returns to the status display.
Important! All settings that have been modified and confirmed with the < E >
key before quitting the setup level are stored automatically.
Note: If no key is pressed in the setup level for 10 minutes, the control unit
automatically returns to the status display.
Condair Dual
ready
language
english
old value
english
Sprache
deutsch
new value
deutsch
language
english
Condair Dual
setup level
language
english
controller funct
off
analog signal
0-10 Vdc ( 81%)
language
english