Comtech EF Data LPOD, Инструкция по установке и эксплуатации

Страница: 147 / 250

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC) MN-LPOD
Serial Interface Operation Revision 14
5–17
Parameter Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments for
Command or
Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of Arguments)
Command Query
Response to
Command
Response to
Query
Retrieve Firmware
Number
N/A FRW? Query only.
Returns the Boot, Bulk1, and Bulk2 firmwares loaded into the unit, each firmware load [a,b,c] is in the form FW-
AAAAAAA B.B.BB DD/MM/YY where:
FW-AAAAAAA=the firmware part number
B.B.BB=the version number
DD/MM/YY=Day/Month/Year firmware released
EXAMPLE: <0001/FRW?{CR}
>0001/FRW={CR}
Boot: {CR}
FW-0000082 0.0.1a 04/09/08{CR}
Bulk1: {CR}
FW-0000078 0.0.1a 04/09/08{CR}
FW-0000080 0.0.1a 04/09/08{CR}
FW-0000081 0.0.1a 04/09/08{CR}
Bulk2: {CR}
FW-0000078 0.0.1a 04/09/08{CR}
FW-0000080 0.0.1a 04/09/08{CR}
FW-0000081 0.0.1a 04/09/08{CR}{LF}
FRW= FRW=Boot:[a]:{
CR}Bulk1:{CR}[a
]{CR}[b]{CR}[c]{
CR}Bulk2:{CR}[a
]{CR}[b]{CR}[c]{
CR}{LF}
Global Amplifier
Configuration
GAC= GAC? 43 bytes Command or Query.
Sets or returns the global status of the LPOD, semicolon delimited, in the form aa.aa;b;ccccc;d;e;f;g;h;j;k;l;m;n;o
where:
a=redundancy mode (ESW)
b=online status (ONL)
cc.cc=Attenuation Offset (AOF)
dd.dd=Customer Attenuation(ATT)
e=Auto Fault Recovery (AFR)
fffff=Unit Alarm Mask (MSK)
g=LNB Current Source (LCS)
hh=LNB Current Window (LCW)
i=LNB Current Window Enable (CWE)
j=Enable Statistics Averaging (ESA)
k=Set Statistics Interval (SSI)
l=Enable Statistics Logging (ESL)
m=Auxiliary Mute (AUX)
n=user mute state (MUT)
o=RF power amplifier state (AMP)
COMMAND EXAMPLE : <0001/GAC=a;b;cc.cc;dd.dd;e;fffff;g;hh;I;j;k;l;m;n;o;{CR}
GAC=
GAC*
GAC?
GAC#
GAC=x….x
Initialize Events
Pointer
IEP= N/A None Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log. This command
takes no arguments.
EXAMPLE: <0001/IEP={CR}
IEP=
IEP?
IEP*
N/A