Comtech EF Data LPOD, Инструкция по установке и эксплуатации

Страница: 112 / 250

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC) MN-LPOD
Ethernet Interface Operation Revision 14
4–20
•
Attenuation Offset – Enter a valid offset value, in dB.
• Fault Recovery
– Use the drop-down list to select
Automatic
or
Manual
.
• Mute
– Use the drop-down list to select
Enabled
or
Disabled
.
• Aux Mute – Use the drop-down list to select Enabled or Disabled .
• Offline Mute – Use the drop-down list to select Enabled , Disabled ,
MuteRx , MuteTx , LNB , LNB , Mute Tx+Amp , or Mute
Tx+LNB+Amp.
Click [Reset] to restore the previously saved settings.
Click [Change Configuration] to save any changes.
Reference
•
Ref Freq Adjust – Enter a valid reference oscillator tuning voltage value
from 0 to 255 . The default value is set to 87.
•
Ext Ref Mute – Use the drop-down list to select the External Reference
Not Present Mute Mode as either Enabled or Disabled .
Click [Reset] to restore the previously saved settings.
Click [Change Configuration] to save any changes.
Low Power Forward Threshold (dBm)
When the forward power monitor is set to Alarm or Fault instead of the factory
default of Mask , and the forward power drops below the specified value, the
alarm/fault occurs.
Set the threshold value, in dBm, for the low forward power alarm/fault.
To disable the threshold, set this parameter to the default value of 00.00.
Click [Change] to save any changes.
FSK Address
Set the FSK (Frequency Shift Keying) Address from 01 to 15 .
Click [Change] to save any changes.