Comtech EF Data HPOD, Инструкция по установке и эксплуатации

Страница: 95 / 161

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Revision 9
Serial-Based Remote Product Management 5–22 MN/HPOD.IOM
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to
Query
Remote
Baud Rate SBR= 4 bytes,
alphanumeri
c Command or Query.
Set remote baud rate in the form xxxx, where:
9600 = 9600 baud
19K2 = 19200 baud
Example: SBR=9600’cr’
Note: When changing baud rates remotely the response to the
command will be returned using the same baud rate as that used
to send the command.
SBR=
SBR? SBR? SBR=xxxx
(See
Description of
Arguments)
Summary
Fault Status N/A 1 byte,
value of 0,1 Query only.
Returns the condition of the summary fault relay where:
0 = Not Faulted (SumFLT_COM J6 pin K is connected to
SumFLT_NO J6 pin L, and SumFLT_NC J6 pin M is open)
1 = Faulted (SumFLT_COM J6 pin K is connected to
SumFLT_NC J6 pin M, and SumFLT_NO J6 pin L is open)
Example: <1/SFS?
>0001/SFS=0’cr’’lf’ N/A SFS? SFS=x
(See
Description of
Arguments)
Remote
Address SPA= 4 bytes,
numeric Command or Query.
Set Physical Address in the form xxxx, where:
xxxx = address between 0001 to 9999, resolution 0001
Example: SPA=0412’cr’
SPA=
SPA? SPA? SPA=xxxx
(See
Description of
Arguments)
Set RTC
Time TIM= 6 bytes,
numeric Command or Query.
Sets or returns the RTC time in the form
hhmmss , where:
hh = hours, between 00 and 23;
mm = minutes, between 00 and 59,
ss = seconds, between 00 and 59
Example: (time = 23 hours, 12 minutes and 59 seconds since
midnight.):
<1/TIM=231259’cr’
>0001/TIM=’cr’’lf’
TIM =
TIM?
TIM* TIM? TIM=xxxxxx
(See
Description of
Arguments)