Comtech EF Data HPOD, Инструкция по установке и эксплуатации

Страница: 66 / 161

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Revision 9
Ethernet-Based Remote Product Management 4–15 MN/HPOD.IOM
4.5.5.3 Config Pages
Click the Config tab, and then select the Amplifier , Utility , or Redundancy hyperlink to
continue.
4.5.5.3.1 Config | Amplifier Page
Use this page to configure the communications, operations, and alarms/faults handling for the
amplifier.
Figure 4-4. Config | Amplifier page
At any time, click [Refresh] to update this page and see the most recent data.
Amplifier

Attenuation (dB) – Enter an attenuation level, in 0.25 dB steps, from 00.00 to 20.00 dB.

Amplifier – Use the drop-down list to set the amplifier as On or Off .

Mute – Use the drop-down list to set the Mute function as Enabled or Disabled .

Overdrive Protection Mode
1
-
Use the drop-down list to set the function as Enabled or
Disabled

Overdrive Activate Level
1 -
Enter a level from P1dB rated to (P1dB rated - 10.00) . Note:
Maximum value can be 10.0. However, current customer attenautation (ATT) setting will
factor into how large the activate level value can be used. For example: if ATT is 22.00 and
ATT max range is 30.0, then maximum value the activate level can set to is 8.0.

Overdrive Mask
1
- Use the drop-down list to set the overdrive mask to Fault or Alarm .
Note: In falut mode, if an overdrive fault is triggered, the amplifier will be muted, and a
summary fault activated. In Alarm mode, only a log is recorded.