Comtech EF Data HPOD, Инструкция по установке и эксплуатации

Страница: 84 / 161

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Revision 9
Serial-Based Remote Product Management 5–11 MN/HPOD.IOM
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to
Query
Overdrive
Protection
Mode OVR= 1 byte,
value of 0, 1 Command or Query.
Sets or returns the overdrive mode in the form x, where:
0=Disabled
(DEFAULT)
1=Enabled
Example: <1/OVR=1’cr’
OVR=
OVR?
OVR* OVR? OVR=x
(See
Description of
Arguments)
Overdrive
Trigger Level OVU= 4 bytes,
numerical Command or Query.
Sets or returns the overdrive trigger level in the form xx.x, where:
xx.x=P1dB rated to (P1dB rated - 10.00, in dB)
Default value: P1dB rated value.
Example: <0001/OVU=42.5{CR}
NOTES:
Maximum value can be 10.0. However, current customer
attenautation (ATT) setting will factor into how large OVU value
can be used. For example: if ATT is 12.00 and ATT max range is
20.0, then maximum value OVU can set to is 8.0.
OVU=
OVU?
OVU* OVU? OVU=xx.x
(See
Description of
Arguments)
Overdrive
Protection
Mode Mask ODF= 1 byte,
value of 0, 1 Command or Query.
Sets or returns the overdrive mode mask in the form x, where:
0= FAULT
1=ALARM
Example: <1/ODF=1’cr’
NOTES: In Fault mode, if an overdrive fault is triggered, the
amplifier will be muted, and a summary fault activated. In Alarm
mode, only a log is recorded.
ODF=
ODF?
ODF* ODF? ODF=x
(See
Description of
Arguments)
Set Backup
Offset SBO= 7 bytes,
numerical Command or Query.
Set or query the adjusted attenuation level, in 0.25 dB
increments, in a 1:2 redundant system so power is equal
between the online and offline units when a switchover occurs. In
the form #,xx.xx where:
# = 1 or 2
xx.xx = level, in 0.25 dB increments
Examples: SBO=1,02.00’cr’ or SBO=2,02.50’cr’
SBO=
SBO?
SBO* SBO? SBO=#,xx.xx
(See
Description of
Arguments)