Comtech EF Data HPOD, Инструкция по установке и эксплуатации

Страница: 85 / 161

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Revision 9
Serial-Based Remote Product Management 5–12 MN/HPOD.IOM
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to
Query
Auxiliary
Mute Enable AUX= 1 byte
value of 0,1 Command or Query.
Enable or disable the auxiliary mute mode, in the form x, where:
0 = Disabled
1 = Enabled
Example: (AUX Mute Enabled): AUX=1’cr’
Note: When enabled, Pin H of the J6 COMM 1 connector must
be grounded to UN-MUTE unit. Otherwise, unit will be muted,
and if a mute query is given (MUT?) the response will be MUT=2
to indicate a hardware-controlled mute is present.
AUX=
AUX?
AUX* AUX? AUX=x
(See
Description of
Arguments)
BUC Mute
State BCM= 1 byte
value of 0,1 Command or Query.
Mute the unit, in the form x, where:
0 = BUC Muted
1 = BUC Not Muted
Example: BCM=1’cr’ would allow the BUC to transmit
Note : Only active if the optional BUC is installed.
BCM=
BCM?
BCM* BCM? BCM=x
(See
Description of
Arguments)
Low Forward
Power
Threshold FPT= 5 bytes,
numerical Command or Query.
Sets or returns the threshold for the low forward power fault in the
form xxx.x:
NOTES:
1) If the forward power drops below the specified value, a fault may
be indicated based on FPA setting.
Example: <0001/FPT=030.0’cr’
FPT=
FPT?
FPT* FPT? FPT=xxx.x
Low Forward
Power Mask FPA= 1 byte
value of 0,1 Command or Query.
Sets or returns the low forward power mask in the form x, where:
0= FAULT
1=MASK
Example: <1/FPA=1’cr’
FPA=
FPA?
FPA* FPA? FPT=x
(See
Description of
Arguments)
Clear All
Stored
Alarms CAA= None Command only.
Clears all Stored Events:
Example:
<1/CAA=’cr’
>0001/CAA=’cr’’lf’
Note: This command takes no arguments.
CAA= N/A N/A