Comtech EF Data HPOD, Инструкция по установке и эксплуатации

Страница: 148 / 161

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Revision 9
Appendix B B–9 MN/HPOD.IOM
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for
Command
or
Response
to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes – i.e.,
ASCII codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
query
(Target to
Controller)
Redundancy
State N/A 1 byte,
value of 0,
1, 2 Query only.
Returns the current redundancy state in the form x, where:
0 = OFF
1 = 1:1 Redundancy
2 = 1:2 Redundancy N/A RED? RED=x
(see
Description of
Arguments
for details)
Set switch
position SSW= 1 byte,
value of 0,1 Command only.
For 1:1 systems only(sent to either unit):
Only used when system is in MANUAL redundancy mode
(RAM=0, both units).
Forces switch position in the form x, where:
1 = Forces switch to put SSPA 1 online
2 = Forces switch to put SSPA 2 online SSW=
SSW? N/A N/A
Gain Offset GOF= 5 bytes,
numerical Command or Query.
Set or query the adjusted attenuation level, in 0.25 dB
increments, in a 1:1 redundancy system so power is equal
between the online and offline units when a switchover occurs,
in the form xx.xx.
Example: GOF=02.00’cr’
GOF=
GOF?
GOF* GOF? GOF =xx.xx
(See
Description of
Arguments
for details)
Set Backup
Offset SBO= 7 bytes,
numerical Command or Query.
Set or query the adjusted attenuation level, in 0.25 dB
increments, in a 1:2 redundancy system so power is equal
between the online and offline units when a switchover occurs.
In the form #,xx.xx where:
# = 1 or 2
xx.xx = level, in 0.25 dB increments
Examples: SBO=1,02.00’cr’ or SBO=2,02.50’cr’
SBO=
SBO?
SBO* SBO? SBO=#,xx.xx
(See
Description of
Arguments
for details)