Comtech EF Data HPOD, Инструкция по установке и эксплуатации

Страница: 147 / 161

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Revision 9
Appendix B B–8 MN/HPOD.IOM
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for
Command
or
Response
to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes – i.e.,
ASCII codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
query
(Target to
Controller)
Force Back-
Up State FBU= 1 byte,
value of 0,
1, 2 Command or Query.
For 1:2 systems only (sent only to the BU unit).
Force one of the online units to be a backed up for maintenance
and test purposes, in the form x, where:
0 = Force BU
OFFLINE and place system in AUTO mode.
1 = Force SSPA 1 OFFLINE and place system in MANUAL
mode.
2 = Force SSPA 2
OFFLINE and place system in MANUAL
mode.
FBU=
FBU? N/A N/A
Online
Status N/A 1 byte,
value of 0,1 Query only.
For 1:1 systems only (sent to both units).
Returns the online status in the form x, where:
0 = OFFLINE
1 = ONLINE ONL=
ONL? ONL? ONL=x
(see
Description of
Arguments
for details)
Configure
Redundancy
Amp CRA= 1 byte
value of 0,1 Command or query.
Permits configuration of the redundancy amplifier mode in 1:1
and 1:2 redundancy systems, in the form x, where:
0 = Disabled - the offline unit's amp state will follow the online
unit's amp state (Default).
1 = Enabled - the offline unit's amp state will be Off, if it
becomes the online unit, then its amp state will be On. This
affects all units in the redundancy system.
Note: The same CRA value should be sent to all units in the
redundancy system.
CRA=
CRA? CRA? CRA=x
(See
Description of
Arguments)
Redundancy
Mode RAM= 1 byte,
value of 0,1 Command or Query.
For 1:1 systems only (sent to both units).
Sets or returns redundancy mode in the form x, where:
0 = MANUAL
1 = AUTO RAM=
RAM? RAM? RAM=x
(see
Description of
Arguments
for details)