Comtech EF Data CDM-Qx, Инструкция по установке и эксплуатации

Страница: 131 / 224

CDM-Qx Satellite Modem Revision 6
EDMAC Channel MN/CDMQx.IOM
7.3 Setup Summary
To access a distant-end unit:
•
Designate a Master/Slave pair: Master at the local-end, Slave at the distant-end.
•
On the local-end unit: Enable framing and EDMAC, define the unit as MASTER,
then enter the bus address. This is constrained to be ‘base 10' meaning that only
addresses such as 10, 20, 30, 40 etc, are allowed.
•
Choose a unique bus address for the distant-end. This should normally be set to
the ‘base 10' a 1. For example, if the MASTER unit is set to 30, choose
31 for the distant-end unit.
•
On the distant-end unit: Enable framing and EDMAC, define the unit as SLAVE,
then enter the bus address. The orange EDMAC Mode LED should be
illuminated.
•
Set the local-end unit to RS485 remote control, and set the bus address of this
local unit. The orange Remote Mode LED should be illuminated.
•
Once the satellite link has been established, connect the M&C Computer, and
begin communications, with both the local and distant end units.
NOTE: EDMAC modes are fully compatible with AUPC modes.
7–3