ComStream CM601, Инструкция по установке и эксплуатации

Страница: 80 / 228

6-8 Front Panel Operation
5. Select BConfig.
6. Scroll to the BERT Error command.
7. Select Insert and press the Enter button.
8. Press the Previous button to return to BConfig>BMonitor.
9. Select BMonitor and verify that a bit error was received. It is not necessary to
scroll down the BMonitor command list.
Example: Comparing Command Parameters on Different Levels
This example is similar to the previous one except that steps are added to check
the AGC level. Perform the following steps to insert a bit error, check the AGC
level, and verify that the bit error is received:
1. Navigate to BConfig>BMonitor.
2. Select BMonitor.
3. Scroll down the BMonitor command list to the BERT BitErr command and
note the number of errors.
4. Press the Previous button to return to BConfig>BMonitor.
5. Select BConfig.
6. Scroll to the BERT Error command.
7. Select Insert and press the Enter button.
8. Press the Previous button three times to return to Config>Monitor>Faults.
9. Select Monitor.
10. Scroll down the Monitor command list to the AGC Level command and note
the value.
11. Press the Previous button to return to Config>Monitor>Faults.
12. Navigate to BConfig>BMonitor.
13. Select BMonitor. In this example the first command in the BMonitor
command list is displayed.
14. Scroll down the BMonitor command list to the BERT BitErr command and
verify that a bit error was received.
Command Display
Configuration commands can be viewed, entered, or modified using the LCD,
Cursor, Modify, and Enter buttons. Other remote commands that are not directly
accessible from a command tree list can be entered using the terminal emulator
(:AA) feature. Monitor and fault messages are view-only.