ComStream CM601, Инструкция по установке и эксплуатации

Страница: 52 / 228

4-8 Installation
b. Configure the terminal as follows:
• 7 data bits
• Odd parity
• 1 stop bit
• 1200 baud
4. Select an AC power cord and connect it to the CM601 IEC receptacle on the
rear panel, and plug the other end into an AC outlet. For additional
information on the power source and rules and regulations for attaching an
international power cord, refer to the Preface of this guide.
5. Power on the CM601. Press the rear panel rocker switch toward the On
position.
6. Monitor the message sequences on the front panel and remote terminal
displays. The power-up message sequences are presented in Table 4-2.
Table 4-2 Power-Up Sequence
Front Panel Power-Up Sequence Remote Terminal Power-Up Sequence
LEDs illuminate for a short time while all
LED lamps are tested CM601 information appears; for example:
ComStream CM601
ID message
Unit serial number
Pass or fail indication for the power-up,
self-test sequence
Power-Up Test Messages:
Power-Up Test in Progress
Power-Up Test Complete
message indicating the test passed or
failed
Information for each card installed in the
CM601 chassis appears:
Card description
Chassis slot location
Software version
Other hardware configuration information
ComStream CM601
identification
message appears indicating power-up is
complete
System prompt (>) appears indicating
power-up is complete
Troubleshooting Tip
If the terminal fails to display the power-up message sequence, check the following:
Cables
Remote terminal baud rate set at 1200
Terminal data/parity set at 7/odd
Once the parameters are correct, turn the power switch off and then back on. Monitor the power-
up message sequence on the remote terminal.