Comrex Access NX, Руководство по эксплуатации продукта

Страница: 51 / 127

51
XVI.
CroSSloCk MENu
These settings determine how the CrossLock reliability layer behaves. Most users should leave these settings as default
Enable - Allow CrossLock connections in general. Default is yes. Note this does not guarantee
connections will be made with CrossLock. Other requirements (CrossLock capable codec on far end,
compatible firmware etc) must be met for CrossLock to function.
Retransmit Delay
- CrossLock automatically provides an extra “Retransmit Cushion” that provides
some time to make ARQ error correction effective. The default amount of time is twice the
measured round trip delay of the network (2xRTT). This has been shown to be most effective on
most networks, but can be altered lower (1xRTT, none) or higher (3xRTT) using this menu.
Redundant Transmission
- Default is off. Most users of portable codecs will prefer the default
“Bonding” mode, which sums the capabilities of networks together. Redundancy disables that
feature, and instead puts all network data simultaneously on all available networks. This is the
preferred mode if your networks are of known high quality and unmetered. In the case of one
network being completely lost, Redundant mode can result in less audio disruption (although in
many cases Bonding mode achieves this as well).
Encoder Throttle
- Allow CrossLock to signal that the local encoder should reduce data rate. Default
is yes.