8–18 Model 2100 and 2200 Ultra SCSI Controller Enclosures User Guide
Installing an Array Controller or Cache Module
Enclosure bays for array controller and cache sets are matched. Compaq recommends
installing a single-set configuration into Controller A and Cache A bays (see Figure 8–10).
For dual redundant configurations, both controller and cache bays are occupied.
NOTE:
An ECB is
required
for each array controller and cache set installed.
Table 8–14 provides procedures for installing an array controller or cache module. For
additional, detailed instructions on installing the array controller, cache module, and
cabling, refer to array controller documentation.
NOTE:
After all enclosure elements are installed and power is applied to the enclosure, refer to
the array controller documentation to configure the array controllers for operation.
Table 8–14 Installing an Array Controller or Cache Module
1.
Refer to array controller documentation for pluggable procedures and install the element.
Otherwise, proceed to step 2 for power-off procedures.
2.
Insert the element into the bay and push the element in until the extractor latches engage the
enclosure.
3.
Push inward on the extractor latches to firmly seat the element.
4.
Configure element cabling using the array controller documentation.
5.
