Removal and Installation Procedures
8–17
Figure 8–12. Cache module removal and installation
WARNING:
When both array controller bays or a cache module bay is empty, a shock
hazard exists on the backplane.
Do not
touch the backplane.
Always install a blank panel in any bay not currently in use.
CAUTION:
If a conflict exists between the replacement procedures within this
document and those within array controller-specific documentation, use procedures
in the array controller documentation.
Removing an Array Controller or Cache Module
Table 8–13 provides the procedure for removing an array controller or cache module.
Table 8–13 Removing an Array Controller or Cache Module
1.
Refer to array controller documentation for pluggable procedures and replace the element.
Otherwise, proceed to step 2 for power-off procedures.
2.
Disconnect any cabling attached to the element.
3.
Simultaneously pull outward on the two extractor latches to remove the element.
4.
To remove a second element, repeat step 2 and step 3.
CXO6929B
