StarTech.com SM2E1BMU31C, Быстрый старт

Страница: 1 / 2

Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: April 20, 2021 3:03 PM
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Product Diagram (SM2E1BMU31C)
Exterior - Enclosure
Component Function
1 Drive-Tray Screws x 2
• Used to secure the
Drive Tray
in the
Enclosure
.
2
Power & Activity LED
• Indicates that the
Enclosure
is receiving
power.
• Blinks during read/write activity.
3
USB-C Port
• Used to connect the Enclosure to the Host
Computer .
Interior - Drive Tray
Component Function
4
Drive Connector • Used to connect the
Drive
to the
Enclosure
.
5
Adjustable Drive
Length Holes
• Used to accommodate different drive lengths.
6
Drive-Mount Screw/
Standoff/Nut
• Used to secure the Drive to the Enclosure .
M.2 SATA/NVMe SSD Enclosure - USB 3.2 (10Gbps) w/ USB-C and USB-A Cables
Package Contents
• M.2 SSD Enclosure x 1
• USB-C to USB-C Cable x 1
• USB-A to USB-C Cable x 1
• Drive Installation Screw Kit x 1
• Micro Screwdriver x 1
• Quick-Start Guide
Product Information
For the latest requirements, please visit
www.startech.com/SM2E1BMU31C
Product Requirements
• M2 SATA/NVMe SSD x 1
• 30 mm, 42 mm, or 60 mm Drive Length
• Needle-nose Pliers x 2
Installation
Installing a Drive
Warning!
Handle drives with care.
1. Remove the
Drive Tray Screws
(x 2) from the
Enclosure
, using a
Phillips Head
Screwdriver , and remove the Cover Plate .
2. Carefully pull the Drive Tray out of the Enclosure .
3. Remove the Drive-Mount Screw , using a Phillips Head Screwdriver .
4. Place the Drive next to the Drive Tray and align the screw holes in the Drive with
the
Adjustable Drive Length Holes
on the
Drive Tray
to determine the desired
Adjustable Drive Length Hole setting.
Note:
If the drive mounting hardware is already installed in the correct position,
proceed to step 8.
5. Remove the
Drive Standoff
and
Nut
, using two sets of
Needle-nose Pliers.
6. Insert the
Drive Standoff
and
Nut
into the
Adjustable Drive Length Hole
(60, 42,
or 30) according to the length of the Drive .
7. Tighten the Standoff and Nut , using two sets of Needle-nose Pliers.
1
2 3
4
6
5