inS_cnge2fe16MS_reV–
01/11/12 Page 45
INSTALLATION AND OPERATION MANUAL
CNGE2FE16MS
TECh SUPPORT: 1.888.678.9427
System Event Log
This feature allows the user to decide whether to send the system event log, and to select the
mode which the system event log will be sent to: client only, server only, or both client and server.
What kind of event log will be issued to the client/server depends on the selection on the
Event
Configuration
tab.
System Event Log—Syslog Configuration
»
Syslog Client Mode
: Select the system log mode—
Client Only
,
Server Only
, or
Both
.
Client Only
means the system event log will only be sent to this interface of the switch, but on
the other hand
Server Only
means the system log will only be sent to the remote system log
server with its IP assigned. If the mode is set in
Both
, the system event log will be sent to the
remote server and this interface.
»
Syslog Server IP Address
: When the
Syslog Mode
item is set as Server Only/Both, the user is
required to assign the system log server IP address to which the log will be sent.
»
Select
Reload
to refresh the event log displaying area.
»
Select
Clear
to clear the displaying area.
»
Make sure the selected mode and IP address, if needed, is correct and select
Apply
to have
the setting take effect.
Figure 46 – Syslog Configuration interface
