45
7.1.5 Cut 2 pieces of spiral wrap, one 5” and one 10” in length.
7.1.6 Wrap the 5” section of spiral wrap around ribbon entering from the
left side
of closure so that it wraps around the
½” core tube. Wrap the 10” section of spiral wrap around ribbon entering from the
right side
of closure. Secure
each spiral wrap to core tube with cable tie. See photos 153-155.
Note:
Straighten steel strength members back into original position
.
7.1.7 If cable is shielded and to be grounded, proceed to
Section 7.2
.
7.1.8 Proceed to
Section 7.3
to assemble cable retention hardware.
7.1.9 Snap cable retention assemblies into the appropriate locations. Secure with bolts if grounded.
See photos 156-158.
Apply spiral wrap.
Core tube
Photo # 153
Secure with cable tie.
Photo # 154
Left
entry
port cable:
5” spiral wrap
Right
entry
port cable: 10”
spiral wrap
Photo #155
Left
side entry
port No ground
Snap into
cavity
Photo #156
Right
side entry
port No ground
Snap into
cavity
Photo #157
Left side & Right side entry
ports. Ground bar & Inline bar
installed
Snap into cavity &
install (3) bolts.
Photo #158
Mini
-
OTE 300 Installation Guide
All
trademarks used in this publication are CommScope registered
201
9
CommScope Inc. All rights Reserv
ed
