Commend SIP Series
Configuration via Web Interface
2.0/0612
51
Configuring Relays
In the sections
Relay 1
and
Relay 2
the following settings can be configured separately for both relays
of the SIP station:
Status:
Indication of the current relay status.
Manual Actions:
Clicking on the buttons in this row triggers the following relay actions directly
from the web interface:
On
: Close relay output (activate)
Off
: Open relay output (deactivate)
Flashing:
Switch relay output to blinking (switch on and off in rhythm of one second)
Door opener
–
door opener function: relay output is closed for a definable time (see below “
Door
opener Timer
”).
Toggle:
Invert current state of the relay output (switch on/off)
DTMF Password Enabled:
If the checkbox is activated, a password has to be entered at the SIP
telephone, (see
DTMF Password
), in order to be able to trigger the respective relay of the SIP sta-
tion via DTMF after dialling at the SIP telephone.
DTMF Password:
The appropriate DTMF password for authorization of DTMF after dialling, for
triggering the relay of the SIP station, at the SIP telephone has to be entered (configuration of but-
tons for DTMF after dialling
see below
).
Button for On
/
Off
/
Flashing
/
Toggle
/
Door opener:
Selection of the desired DTMF-button (0–9, *, #) of a SIP telephone for control of the relay outputs
(see above). Control of the relays is carried out via DTMF after dialling during the conversation.
Door opener Timer
: Enter the time in seconds how long the relay shall stay active after pressing
the door opener button.
Configure Relay as Attendant Contact
In the sections
Attendant Contacts Relay 1
and
Attendant Contacts Relay 2
it is possible to
separately configure the relays as attendant contact for the following states:
Outgoing Call
– Outgoing call from the SIP station
Incoming Call
– Outgoing call to the SIP station
In Call
– Active conversation (between two SIP stations)
Standby
– Idle state of the SIP station
Error
– Registration of station not possible, due to e.g. fault in connection to the SIP server, si-
gnalling or other problems.
P
ROCESS
OF
E
NTERING
THE
P
ASSWORD
:
After pressing a button at the telephone, an appropriate prerecorded audio file (“Password”) is si-
gnalling that the password has to be entered now (“password mode”).
With it a timer of 10 seconds is started.
If no button is pressed within these 10 seconds, then the “password mode” is cancelled.
If the correct button for the respective digit of the defined
DTMF Password
has been pressed within
the 10 seconds, then the 10 seconds timer is restarted for entering the next digit of the password.
If the entered password is not correct, then a double tone is put out and the “password mode” is
cancelled.
If the entered password is correct, then a single tone is put out and the appropriate relay of the SIP
station is triggered.
Default: 2 seconds
Note:
The “attendant contacts” (i.e. the relay outputs) will stay in the triggered mode, as long as the respective
state is active (for relay modes
see below
.
Note:
Standby = registered at SIP Server or at server less operation: ready for operation.
