4K HDBaseT 4x4 Matrix Switcher
with comma).
[x1] R[x2].
Transfer the IR signal from output [x1] to
input [x2].
IR:
X1-> X2(X1
、
X2=01~04)
Status[x].
Check the I/O connection status of
output [x]
AV: Y-> X
(X=01~04, Y=01~04)
Status.
Inquire the input channel to the output
channels one by one.
AV: 01->01
……
AV: 04->04
IR: 01->01
……
IR: 04->04
Save[Y].
Save the present operation to the preset
command [Y], ranges from 0 to 9.
Save
To
FY
(Y=0-9)
Recall[Y].
Recall the preset command [Y].
Recall
From
FY
(Y=0-9)
Clear[Y].
Clear the preset command [Y].
Clear FY (Y=0-9)
PWON.
Work in normal mode.
PWON
PWOFF.
Enter into standby mode and cut off the
power supply to HDBaseT receivers.
PWOFF
STANDBY.
Enter into standby mode. (Do not cut off
the power supply to HDBaseT receivers,
press other buttons or send other
commands to start.)
STANDBY
/%[Y]/[X]:[Z].
HDCP management command.
[Y] is for input (value: I) or output (value:
O); [X] is the number of the port, if the
value of X is ALL, it means all ports; [Z]
is for HDCP compliant status, the value
may be 1 (HDCP compliant) or 0 (not
HDCP compliant).
/%[Y]/[X]:[Z].
DigitAudioON[
x].
Enable HDMI audio output of port x.
● X=1, 2, 3, 4, enable this port.
● X=5, enable all the 4 ports.
DigitAudio ON with
[x]
DigitAudioOF
F[x].
Disable HDMI audio output of port x.
● X=1, 2, 3, 4, disable this port.
● X=5, disable all the 4 ports.
DigitAudio OFF with
[x]
/+[Y]/[X]:******
.
Set communication between PC and
HDBaseT receiver.
1
Y is for RS232 port (connect with
RS232 port of HDBaseT receiver)
Y= 1~5 or A~H, The value of Y is
defined into the following meanings
(in a given baud rate depended by
the value of X):
******
Comm-tec Srl
25
www.comm-tec.it
