4K HDBaseT 4x4 Matrix Switcher
The interface of the control software is showed as below:
Please set the parameters of COM number, baud rate, data bit, stop bit and the
parity bit correctly, only then will you be able to send command in Command
Sending Area.
4.3.6
RS232 Communication Commands
Note
:
1)
Please disconnect all the twisted pairs before sending command
EDIDUpgrade[X].
2)
In above commands, “[”and “]” are symbols for easy reading and do not need to
be typed in actual operation.
3)
Please remember to end the commands with the ending symbols “.” and “;”.
4)
Type the command carefully, it is case-sensitive.
Baud rate: 9600 Data bit: 8 Stop bit: 1 Parity bit: none
Comm-tec Srl
23
www.comm-tec.it
