Comm Net Systems v30/30, Руководство по установке и эксплуатации

Страница: 21 / 30

V30/30 DISTRIBUTION PANEL
SETUP AND OPERATION MANUAL
OPERATION - PAGE 15
5.7 Review System Status via the Embedded Web Server
The optional embedded Ethernet module provides remote monitoring via IP-based Ethernet networks and a web browser. To view
the system status, you will need to connect the Ethernet port on the rear of your v30/30 distribution panel to your network.
By default, the Ethernet module is configured from the factory with a static IP address and network settings, as defined below.
5.7.1 Default Static Network Settings
Use these default settings to set up a local network to communicate with the embedded web server:
y
IPV4 Address: 192.168.123.123
y Subnet Mask: 255.255.255.0
y Default Gateway: 192.168.123.1
y Primary DNS: 192.168.123.1
y
Secondary DNS: 8.8.8.8
Once you establish a connection to the embedded Ethernet module, use the following credentials to gain access to the protected
data and administrative pages:
y Username:
root
Password:
password
5.7.2 Real-time Status
Upon loading the v30/30 web server, the real-time status will be displayed.
Site Information
User can configure these settings under Administration --> Site Settings.
y Site name
y
Site location
bus Detail
y
Voltage
y Feeder fuse size
y Load
y Alarm threshold %
y
Load % based on feeder fuse size
Internal Temperature Sensor
y
Controller temperature sensor in fahrenheit and celsius
External Temperature Sensor
y
Up to (4) external temperature sensors in fahrenheit and celsius
Module Detail
y
SNMP channel mapping
y Channel no.
y Load per channel
y Ampacity per channel
y
Breaker inventory status
y Breaker status (NN/NFF)