ComAp InteliVision 8, Руководство пользователя

Страница: 11 / 96

InteliVision 8
11
3.2.2 Automatic detection
There is implemented the function “Automatic detection of controller address” see How to connect IV8
display to IGS-NT or ID controller? on page 10 . The feature helps you quickly find controller or terminal
address without knowledge of communication parameters of controller.
Note: It is recommended to use automatic detection only in case the communication parameters of the
controller are not available.
IMPORTANT: During detection phase, InteliVision 8 stops communicating with already connected
controller – it is switched to initialization screen – and communication with the actual controller is
lost.
It is possible to detect:
Controller address and terminal address on CAN
Terminal address on display terminal or RS485
After detection phase the first available active address of the controller is set. If you go to the list of addresses
(press Enter on item Controller Adr. ), you will see green and grey numbers.
Green colour means that detected controller is active – the address is occupied with communicating
controller (it is possible to choose the address).
Grey colour means the controller was not detected. That means the address:
can be used with non-communicating controller – for example controller has set some of parameters
incorrectly
the address is not occupied with another controller
Image 3.3 Address detection