InteliLite
NT
– MRS3,4, AMF8,9, SW version 1.4, ©ComAp – October 2008 54
IL-NT-MRS3,4-AMF8,9-1.4-Reference Guide.pdf
IL-NT-RD Remote display software
This chapter describes Remote display software IL-NT-RD, which is designed as an remote signalling
and control software for InteliLite-NT and InteliDrive Lite controllers.
It is the optional software which
is possible to upload into controller instead of standard controller’s firmware.
General description
Remote display software works as “remote display and control” for the master InteliLite-NT or
InteliDrive Lite controller. Genset/Engines can be controlled from remote display as well as from
master controller. All remote display screens (Measure, Setpoints and History) displays the same data
like master controller. Front panel buttons on both controllers work the same way. All remote display
LED’s shows the same state as corresponding LED’s on master controller.
Warning !
It is highly recommended to use the same type and model of controller for master and remote
display. Only in such case is assured the proper function of all buttons, LED diods and display.
Another combinations of HW types and models from Master controller and remote display are
not supported nor tested!
IL-NT-RD Software installation
The IL-NT-RD remote display firmware is installed in the same way as any other IL-NT firmware using
LiteEdit software. Please see LiteEdit Reference guide for details about upgrading firmware. IL-NT-RD
consists only firmware, not an archive.
However when there is IL-NT-RD firmware installed in the controller the procedure to install back the
original standard firmware is following:
•
Open any type of online connection.
•
DDE server will try to open the connection, but it will fail and write red error message in the
status bar.
•
In this moment go to
C
ONTROLLER
->
P
ROGRAMMING AND CLONING
->
P
ROGRAMMING
and select
proper!
firmware you want program to the controller. Choosing the wrong type of firmware
