InteliLite
NT
– MRS3,4, AMF8,9, SW version 1.4, ©ComAp – October 2008 28
IL-NT-MRS3,4-AMF8,9-1.4-Reference Guide.pdf
Set to:
Over Limit
Contact type
: selection of polarity only when analog input is configured as Binary or Tri-state. When
is analog input configured as analog this setting has no sense.
„NC“ – polarity of binary or tri-state input
„NO“ – polarity of binary or tri-state input
Sensor
: selection of sensor characteristic
„Unused input“ - when Analog input is not used. On the InteliLite screen is displayed „####“ value, no
alarm is detected.
Default user curves predefined on AI1 – AI3:
„VDO 10 Bar“ – VDO pressure sensor
„VDO 40-120 °C“ – VDO temperature sensor
„VDO level %“ – VDO level sensor
Set to:
VDO 40-120 °C
When you choose the predefined or user curve the Sensor Name, Dim and Resolution are setted
automaticly according to curve, user modification is possible.
Sensor Name
: Name of used sensor, up to 14 letters can be used.
Dim
: Name of measured unit (Bar, °C, %, …), up to 4 letters can be used.
Resolution
: setting of resolution of measured value.
„0“ - e.g. 360 kPa, 100%, 50
°
C
„1“ – e.g. 360.0 kPa
„2“-
e.g. 360.00 kPa
„3“ -
e.g. 360.000 kPa
Set to:
1
When Analog input configuration is finished set the setpoints AI1 Wrn
,
AI
1
Sd
,
AI
1 Del
in
Basic
setting
group.
Number of decimal points of
AI
x
Wrn and AI
x Sd
is the same as the configured number of decimal
points of measured value.
Binary inputs
+
Battery
-
iL
4k7
Ω
+
-
Power
Supply
