Page | 39
TXF
Filling Ink
Follow these steps to install the Waste Bottle:
Step 1:
Enable the
Service Mode
.
Step 2:
Press the
Menu
button from the Control Panel of the Print Engine, as shown below:
Fig 41: Displaying the Control Panel
Step 3:
Press up or down button and select the
SUB MENU
option from the list, as shown below:
Fig 42: Selecting the SUB MENU Option
Step 4:
Press the right arrow button and select the
INK FILLING
option.
Step 5:
Press up or down button and select the
INK TYPE
option from the list. After selecting this option,
press the
ENTER
key from the keyboard. The list of ink types appears on the screen.
Step 6:
Press up or down button to select the ink type, as shown below:
Step 7:
Press the
ENTER
button to confirm the selection.
Step 8:
After selecting the ink type, press left or right button. If the
Yes
option is selected, then redirected
to the next step otherwise the process gets restarted and the
SUB MENU
screen appears again, as shown
below:
Fig 43: Confirming the Ink Type Selection
Step 9:
Press the
ENTER
key to confirm the selection.
Now, instructions get appeared on the screen. Follow the instructions carefully.
