Cognex In-Sight 3400, Руководство пользователя

Страница: 31 / 90

Installing the In-Sight
®
3400 Vision Senso r
3. Select Network to open the Network dialog (Figure 2-12).
Figure 2-12: Network Dialog
4. Verify that the Use DHCP Server checkbox is disabled.
Each of the Network dialog settings is explained in the following section. For more information,
refer to the
In-Sight
®
Explorer Help file.
Use DHCP Server
The Use DHCP Server checkbox determines whether the In-Sight 3400 sensor uses DHCP on
start up or if the values in the Network dialog will configure TCP/IP.
NOTE
This box should be checked only if a DHCP server is running on the local network. If a
DHCP server does not respond within 60 seconds after startup, the sensor will boot
without network support enabled.
If the network has a DHCP server and the Use DHCP Server check box is enabled, the DHCP
server will automatically configure the In-Sight 3400 sensor’s network settings on startup.
Optionally, a new Host Name may be assigned.
When the Use DHCP Server checkbox is disabled, all Network dialog settings are enabled and
must be configured manually.
IP Address
The IP Address assigns a unique identifier for each In-Sight sensor on the network, which must
be consistent with the IP address-numbering scheme of the local network.
NOTE The IP Address setting is grayed out when the Use DHCP Server checkbox is enabled.
19