Cognex In-Sight 3400, Руководство пользователя

Страница: 28 / 90

In-Sight 3400 Installation
DB15 Connector
DB9 Connector
2-pin Power
Adapter Plug
GND +24VDC
I/O
Figure 2-10: Model 1450 I/O Expansion Module Connections
To Connect the Model 1450 I/O Expansion Module to the In-Sight
3400 Sensor:
1. Verify the 24VDC power supply being used is switched off.
2. Optionally, connect the power and ground wires for the acquisition trigger input, discrete
outputs and discrete inputs to their corresponding terminals on the Model 1450 I/O
Expansion Module.
NOTE
The 1450 I/O Expansion Module outputs labeled HSOUT 0 and HSOUT 1 are high-
speed outputs direct from the In-Sight 3400 sensor and pass through the Expansion
Module. The outputs labeled OUT 0 through OUT 7 are lower speed because their
signals are processed by the Expansion Module processor before being sent to remote
devices.
3. Optionally, connect the DB9 male connector of an RS-232 serial cable to the corresponding
DB9 female connector on the Model I/O 1450 Expansion Module.
4. Plug the I/O Module Cable’s DB15 male connector into the corresponding female connector
on the Expansion Module.
5. Plug the M12 connector of the Model 1450 I/O Module Cable into the In-Sight 3400 sensor’s
24VDC connector.
6. Plug wire leads from a 24VDC supply for the +24V power and ground into the 2-pin terminal
plug labeled “Power Input” on the Expansion Module. Alternatively, remove the terminal plug
and insert the 2-pin terminal plug attached to the In-Sight power adapter into the keyed
power adapter port on the Expansion Module (Figure 2-10).
7. Restore power to the 24V supply. The green PWR LED on the In-Sight 3400 sensor and the
+24V LED on the Expansion Module will indicate that the In-Sight 3400 sensor is receiving
power.
16