Cognex In-Sight 1000, Инструкция по установке

Страница: 13 / 46

Installing In-Sight™ 1000 Series Vision Sensors Section 1: Introduction
5
1.3.2 Factory-Floor In-Sight Network Configurations
To take full advantage of their data sharing and remote monitoring capabilities, In-Sight
sensors should be connected to the larger, factory-floor network. The only physical
difference between factory-networked In-Sight sensors and a standalone In-Sight
network is that the Ethernet switch is itself connected to the factory-floor network.
Groups of In-Sight systems connected to the factory-floor network through a common
Ethernet switch are referred to as a local network, or subnet. Figure 1-5 shows a
subnet that includes two In-Sight 1000 sensors, an In-Sight 3000, and an In-Sight PC
Host.
Figure 1-5: Multiple In-Sight 1000 Sensors with In-Sight 3000 and PC Host
NOTE In-Sight 1000 sensors can be connected to the factory network even if there is no In-Sight PC
Host or In-Sight 3000 sensor on the local subnet. In this configuration, any In-Sight 3000
processor or PC Host on any other subnet on the network can provide remote configuration and
display service to the In-Sight 1000 sensors.