32
CHAPTER 3
®
In order to avoid errors in the coins counting inside the tubes and in the quantity of coins
set in programming, we suggest to load the tubes by means of the “1.3 Manual Recharge”
function.
<
Press the
Enter
key to see the value currently present in the counters;
press the
Enter
key again to get the tube counters to the value set in the “12.8-12.1 Maximum
1.3 Manual Recharge
It foresees the coin loading into the tubes by using the coin automatic counting on the
Validator/Separator group side. On the display is shown the number of coins counted for each
tube. In all the loading functions the coins introduced are added to the “3.1.2.4 Manual Charge”
menu item.
1.4 Reset All
It permits the simultaneous coin counters reset in the tubes.
<
Press the
Enter
key to see the value currently present in the counters;
press the
Enter
key to apply the reset function.
2 Diagnostics
[Operator (
), Technician (
), User (
)]
This menu item permits to perform some tests to check the correct operation of the Coin
Mechanism. Inside this menu there are the following items:
•
2.1 Firmware Rel.;
•
2.2 Tube Unit;
•
2.3 Coin Validator;
•
2.4 Key Parameter.
2.1 Firmware Release
This menu item permits to display: the firmware code (
f
= firmware) and the release of the base
board (
r
= release), the issue date of the firmware (
d
= date) and the checksum (
c
= checksum).
2.2 Tube Unit
The diagnostics of the tubes group foresees the possibility of performing some tests concerning
the coin distribution. All the amounts distributed by the Coin Mechanism after some operations
of manual unload of the tubes are added to the “3.1.4.3 Manual Unload” menu item.
•
2.2.1 Manual Distrib.;
•
2.2.2 Sequential Dis;
•
2.2.3 Empty Tube 1;
•
2.2.4 Empty Tube 2;
•
2.2.5 Empty Tube 3;
•
2.2.6 Empty Tube 4;
•
2.2.7 Empty Tube 5;
•
2.2.8 Empty Tubes;
•
2.2.9 Tube Photocells;
Preset Amount
[65 57 52 52 55]
Reset All
[65 57 52 52 55]
Reset All
[00 00 00 00 00]
fXXXX-XXX rX.XX
dDD-MM-YY cXXXX
