22
CHAPTER 2
®
2.1.3. Installation modes
To carry out the installation of the
Aeterna Coin Mechanism it is necessary
to remove the Tube group by keeping it
firmly by the handle and by lowering the
lever which blocks it mechanically.
fig. 25
Release the Validator/Separator group
from the Coin Mechanism base by acting
on the fastening clips which are placed
in the lower side of the Validator/
Separator group.
Lean two fingers against the clips
placed on the Coin Mechanism base (fig.
26) and push downwards and slowly till
the Validator/Separator group is
released.
Turn the Validator/Separator group
upwards (or remove it by disconnecting
the harnesses beforehand), place the
Coin Mechanism on the holes prepared
inside the vending machine. Fasten the
Coin Mechanism.
fig. 26
1= Cylindrical pin for Validator/Separa-
tor group alignment
2= Fastening clip
3= Slots for pins of the Validator/
Separator
4= Alignment hole for the Validator/
Separator group alignment
Place the the Validator/Separator group by leaning it upwards in the proper slots. Make the
alignment hole, placed in the lower part of the Validator/Separator group coincide with the
1
2
3
4
