Coemar i spot FLEX, Инструкция по эксплуатации

Страница: 19 / 40

19
6) To replace the color simply align the color with the slot and press
inward until the color seats and the outer edge aligns with the other
colors. Orientation of the color filter to the lamp is important. Refer
to Figure W17 to determine the coated side of the color filter and
always orient the filter with the coated side to the lamp. Retighten
the hub screws.
7) Replace the belt on the color wheel and over the motor pulley then
replace the color wheel on the shaft. Repeat for the second color
wheel.
8) Install the screw and washer on the top of the color wheel shaft
to retain the color wheels. DO NOT OVERTIGHTEN . Check to
insure that the wheels rotate freely.
Figure W16 Removing Color Filter
Obtaining replacement colors for your Flex :
Your new
Flex
produces very high energy levels. To withstand this level of energy, coemar uses only the most advanced dichroic
filter technology available. To insure continued performance of your
Flex
we recommend that you utilize only
coemar
dichroic
filters. Contact your
coemar
representative to obtain replacement dichroic filters.
Orientation of colors / gobos / effects:
Use the Figure W17 below to aid in identifying the coated side of the
dichroic filters. The coated side should always be oriented toward
the lamp to minimize heating of the dichroic filter. When using a
metal gobo install the gobo with the painted side
AWAY from the
lamp. Texutred glass should be installed with the texured surface
AWAY from the glass.
Changing Gobos on Color+Gobo Module:
Remove the top cover of the fixture and locate the Color+Gobo
module as in Figure W12. Turn the two quarter turn fasteners one
quarter turn counter-clockwise, then grasp the module by the metal
frame and pull it straight out from the fixture. Lay the module on a
work surface with the color wheels up.
DO NOT lay the module on
the color wheels. Remove the gobos from the module as follows:
Figure W17 Determining Coated Side of Dichroic
Gobo Wheel 1 :
1) Rotate the gobo you wish to change under the opening in the
gobo plate. Hold the gobo gear on the underside of the plate by
hand while you unscrew the retaining ring using the gobo tool
provided with a counter-clockwise rotation. Remove the spring
and gobo.
Figure W18 Remove Gobo
2) Install the gobo with the coated side directed toward the top (color wheel up)
followed by the spring and retaining ring. Refer to Figure W17 for assistance
in determining the coated side. When using a metal gobo install the gobo
with the painted side
AWAY from the lamp. Texutred glass should be
installed with the texured surface AWAY from the lamp
Figure W19 Gobo Tool and Component Parts
UNCOATED SIDE
UNCOATED SIDE