19.2 Selecting the frequency of the power supply of the ColourCyc 250 LX
After having removed the rear panel of the
ColourCyc 250 C
and removed the circuit board panel, as shown previously:
1) Locate the power supply on the right of the base.
2) Select from either 50 or 60Hz by moving cables n° 10 and 11 to the required position. To ensure you have selected the correct
tap, refer to the sticker located on the power supply.
3) Connection 16 should not be moved under any circumstances. If in doubt, consult the circuit diagram or refer the unit to spe-
cialist trained personnel.
Upon completion of this operation, replace all panels and close up the unit as
Attention!
Incorrect selection of either the voltage or the frequency will immediately null and void the warranty of the fixtu-
re and may cause irreparable damage.
25
English
