ColourCyc 250 LX
is compatible with the bidirectional transmission protocol
dr1
.
Using the
dr1
controller (display remote) it is posssible to view and alter parameters remotely.
The input code for the
dr1
is:
PCO9703
The remote parameters available via
dr1
are:
Readouts:
1) Fan state
2) Software version
3) Temperature readout
4) Fan speed
5) Lamp life
6) Projector life
7) DMX 512 state and characteristics
8) Error messages
Control:
1) DMX addressing
2) Turning on the lamp
3) Setting Master/Slave state
4) Projector reset
5) Motor testing
6) Automated program operation and parameter settings
7) Motor alignment
To set up the dialog between the
ColourCyc 250 LX
and the
dr1
you must install it in the DMX 512 line, paying close attention
to the instructions within the unit.
The
DR1 remote
dip switch must be switched to the
ON
position. At this point, the dip switches which set from 1 to 128 are
used to set the identity number (ID) of the unit, not the DMX address, which is set by
dr1
.
The highest ID number accepted by the
dr1
system is 250; dip-switch 256 has no function in this operating mode.
The ID number is achieved by summing the individual dip-switch values. For example:
ID
9
is achieved by setting dip-switches
3-4-2
to the
ON
position.
ID
50
is achieved by setting dip-switches
2-32-16
to the
ON
position.
eg. ID n° 35 ON (32+2+1) :
ON
ON
1
2
4
8
16
32
64
128
256
DR1
remote
No function
15. Remote operation using
dr1
English
18
