Cobalt Digital Inc BBG-1070-QS, Руководство по эксплуатации продукта

Страница: 35 / 92

BBG1070QS-OM (V1.8) BBG-1070-QS PRODUCT MANUAL
3-13
Setup/Operating Instructions
BBG-1070-QS Function Menu List and Descriptions
PIP Clone Global Controls
Provides controls to set global “cloning” of graphics
attributes settings from one PiP to another. This helps in
providing a consistent and easily set layout across
selected PiPs.
Cloned settings can significantly affect layouts. Make certain all aspects of layouts/attributes are understood (as
described in this Chapter) before applying clones to other PiPs. Make certain only desired attributes are cloned as
intended (using the controls described below). Individual tabs also have clone controls which can be used to clone
only certain layout attributes to other PiPs as desired.
Note: • When cloned settings are applied, they can be left as is, or changed as desired on the PiP receiving the cloned
settings. The cloning can serve as a baseline or as the final intended setup as desired.
• For multi-unit setup using Cascade Config mode/setup, Clone Settings from any of the units in the chain can be
cloned to any unit in the chain (i.e., all units in the chain appear in the Clone Settings From and Clone Settings To
drop-downs). See Cascade Config Setup Controls (p. 3-41) for more information.
• Clone Settings From/To PiP Selector Clone Settings From and Clone Settings To drop-downs select the PiP
to serve as the cloned source, and the PiP(s) to receive the cloned
settings.
• Clone Settings Attribute Select (Settings to
Clone)
Check boxes allow all (global), or only certain attributes to be cloned to a
receiving PiP(s) as desired.
Table 3-1 BBG-1070-QS Function Menu List — continued
In the example here, PIP 1 is the settings source to be cloned for PIP 3. The Confirm pop-up allows applying or backing out of
the clone operation.
Note: This dialog is also present on several layout tabs (for example, “Tally Lamps”) described later in this Chapter. As such,
cloning can be performed on this page/tab, or on tabs specific to a particular function.
In the example here, specifically the Audio Meter Overlays and Tally Lamps settings will be applied to the cloned PiPs. Any
combination of checks can be applied as desired.