CNC Seig X2, Руководство по сборке

Страница: 33 / 35

The following slides are instructions for fine tuning the machine axis for movement. Before you start, you will
need:
An electric drill
Some grease
– lithium is best but really, any grease will do.
Your hex key wrenche
A small adjustable wrench (Crescent)
Some good music
And a lot of patience
Also, please refer to your machines operators manual for adjustment of the gibs. This is extremely important!!!If
the gibs are too tight, the machine will not move properly. And, if the stepper motors are installed at this point,
they may bind and stall.
On the X and Y ball nut mounts there is a locking set screw that sets the ball nut in place. These must be
tightened before starting the final adjustments.
The Z axis assembly comes pre-set, but make sure that the locking set screws are tightened securely in case they
were missed at assembly
Place a nice coat of grease on all dovetails, all ball screws and thrust bearings during assembly