CNC Seig X2, Руководство по сборке

Страница: 15 / 35

Clamp bar….slide it inside the column.
Note, there is a 3/8-16 tapped hole in
top of this bar. It must go up! This bolt is
also useful to hold the bar while
attaching the screws that connect it to
the column.
Align the holes in the clamp bar and
use the screws provided, attach it to
the column by putting the screws
into the holes on the column that the
rack gear was attached to. There are
4 ¾” long stainless 10 -24 cap screws
installed into the bar when shipped.
Tighten securely but do not over-
tighten.