Tap Spindle (if you use a HF Spindle):
● Lower RPM limit: 6000 rpm
● Upper RPM limit: 2400 rpm
Figure 3.2.2
Please refer the datasheet (from spindle manufacturer) of your milling spindle
for the exact connections and speed limits.
Tap Inputs:
End-switch 1, 2, 3;Probe input (SE); Error input(FE)
● Enabled: on
● Inverted: on
● Pull up 5V: off
See Figure 3.5.1 below.
3.3 Programm the CNC Motion Controller
Programming the CNC motion controller card with the help of the Estlcam software
Tap basic settings:
Press the Button: „Programm Arduino“
3.4
Preparation
Tools:
You need a voltage meter and a through tester or a corresponding instrument.
You also need a short piece of wire with 3mm naked ends
as a wire bridge, and a small screwdriver.
