3.7
Testing the driver ports (optional)
Test your XYZ and step xyz with the help of an oscilloscope:
For this purpose we put scanner tip 1 on dir x and GND and scanner tip 2 at step x and
GND. If your oscilloscope only has one scanner, you can carry out the measurements
sequentially.
Figure 3.7.1
In the Estlcam Software:
Open „View->CNC Controller (F2)“.
Process the X axis.
Figure 3.7.2
Depending on the direction in which you use X method, the measured values shown in
Figure 3.7.3 are as follows.