Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 45
Support: +49 (0)2831/91021-50
31.03.2014
6
Installation and commissioning
6 . 1
S a f e t y i n s t r u c t i o n s f o r t h e i n s t a l l a t i o n a n d c o m m i s s i o n i n g
Suspended loads
WARNING:
Danger to life due to suspended loads!
When lifting, loads can swing out and fall off. This may lead to serious injury or
death.
•
Never stand under or into the swivel area of a suspended load.
•
Loads are only to be moved only under supervision.
•
Use only approved lifting gear and lifting gear with sufficient load-bearing
capacity.
•
Do not use damaged or frayed lifting equipment such as ropes and straps.
•
Lifting equipment such as ropes and straps must not be laid on sharp edges
and corners do not twist or knot.
•
When leaving the workplace settle the load.
Improper installation and commissioning
WARNING:
Risk of injury by improper installation and commissioning!
Improper installation and commissioning can lead to severe injuries and substantial
property damage.
•
Before starting any work sufficient installation freedom is required.
•
Handle open, sharp-edged components with care.
•
Maintain order and cleanliness at the installation site! Loosely stacked or
scattered components and tools are accident sources.
•
Install components professionally. Comply with the specified screw
tightening torques.
•
Secure components so they do not fall down or fall over.
•
Note following guidelines before commissioning:
Ensure that all installation work in accordance with the information and
instructions were carried out and completed in this guide. Ensure that there are
no persons in the danger zone.
