Clore Automotive Pro-Logix PL2410, Руководство оператора

Страница: 6 / 28

BATTERY CHARGING SETTINGS
Upon making a proper battery connection (see Section
F or G as applicable), plug AC power cord into an AC
receptacle. All unit LEDs will light momentarily, then only
the LEDs corresponding to charging settings should stay
lit. The charger is now in Standby Mode.
If an ERROR Indicator LED lights, disconnect from AC
power supply immediately and determine the cause of the
alarm. The POLARITY light indicates reverse polarity error
connection, while the ERROR light indicates the detection
of a battery fault, such as a shorted connection.
To charge a battery:
1. Choose a battery voltage charge setting. The default
setting is the 12V mode, which will apply to most
charging applications. To charge in 24V mode, push
the voltage setting button until the “24V” LED is lit.
2. Choose a battery type setting. To charge Standard
and Maintenance Free Flooded Acid batteries, push
the Battery Type button until the “STD” LED is lit. To
charge AGM batteries, push the Battery Type button
until the “AGM” LED is lit. To charge Gel Cell, push
the Battery Type button until the “GEL” LED is lit.
3. Choose a battery charging rate. Small batteries found
in lawn and garden, motorcycle or ATV applications
should be charged in the lowest possible charge rate
setting.
4. Press the “CHARGE” button and the charging
indicator LED will light. The charger will automatically
commence and complete the charging process. If you
press the “CHARGE” button at any point during the
charging sequence, the charger will stop charging and
return to Standby Mode.
Note: If the ERROR LED lights, disconnect from AC
power immediately and determine the cause of the
alarm. See Additional Features for a list of conditions
that might cause this warning. If “Ohc” is shown
on the display, the charger has entered overheat
protection mode. See Additional Features for details.
Note: The charger is designed to protect against faults
and shorts (see Battery Charger Features). If the
battery to be charged has a open circuit voltage of
less than 1V, the charger will indicate a fault. If, after
unplugging unit, checking connections and verifying
all settings, you determine the problem causing the
“fault” condition is battery voltage below 1V, you can
override the charger’s protection by holding down the
“CHARGE” button for 3 seconds. The charger will
commence the charging sequence and, assuming
these are no other hindrances that caused the fault
indication, will complete the charging process and
automatically turn off when the battery has reached
full charge.
5. When the battery approaches full charge and enters
the Completion Phase, the green CHARGING
COMPLETE indicator will light and the CHARGING IN
PROGRESS indicator will flash. At this point, if time is
critical, the battery can be put into service if it will be
used in a charging situation, such as in a vehicle that
that will be used immediately. To reach a true 100%
state of charge, the charger should stay connected
until the charger reaches the Rest Phase, when only
the green CHARGING COMPLETE is lit.
6. When you are finished with the charging process,
disconnect AC power cord from AC outlet, then
disconnect DC leads from vehicle ground (if charging
with battery in vehicle) and battery in the reverse
sequence of the connection procedure.
OPERATING INSTRUCTIONS
H
Battery Voltage Indicators Battery Type Indicators
Battery Rate Indicators
Display
Charging
Indicator
Charge
Complete
Indicator
Error Indicator
Start/Stop Charging Selector
Display Info Selector
Display Info Indicators
Reverse Polarity Indicator
Battery Volts Selector
Battery Type Selector
Charge Rate Selector
STATUS CENTER
CONTROL CENTER
CHARGING IN PROGRESS
CHARGING COMPLETE
POLARITY ERROR
VOLTS
12V STD 2A
24V AGM 6A
GEL PWR 10A
TYPE RATE
% CHARGE VOLTAGE
CHARGE
1 2 3
-LOGIX
TM PL2410