Climax FF7200, Руководство по эксплуатации

Страница: 53 / 146

P/N 59129, Rev. 9 Page 45
Grinding attachment setup
1. Set up the ID machine in the flange.
2. Install the grinding head to the arm.
3. Screws mount the grinder to the face of the tool head.
4. Attach hoses to the grinding attachment and rotary union. See the Airline Connection section.
5. Adjust leveling screws until you achieve the desired grinding angle.
6. Use height-adjusting screw on the grinding head to adjust the height.
7. Make sure the guard is in place and all fasteners are tight.
Airline Connection
When using the grinding attachment, the port on the
rotary union used for the pneumatic feed also supplies
air to the grinder motor.
1. Detach the blue 1/4" tube from the large fitting
by pressing inward on the green ring while
pulling out the tubing.
2. Remove the fitting from the rotary union. Install
the elbow fitting shown in the next photo.
3. Cap or plug the end of the blue tubing to prevent
contamination from entering.
Operation
Grinding should be done after the flange has been cut flat with a single point tool or the milling
head.
1. Turn on the grinding head and ramp to the desired operating speed.
2. Set the spindle to touch the surface and make a light grind.
3. Check the surface finish.
4. Make any necessary adjustments to the grinder settings.
5. When the finish is satisfactory, continue grinding the surface as required.
CAUTION
Stay clear of the grinder and wear proper
respiratory protection during operation, to avoid
breathing in grinding residue.
6. When the grinding operation is complete, lift the spindle and shut off the grinder.
Red dots indicate the adjustment points
for leveling the grinder to the surface.