Climax FF7200, Руководство по эксплуатации

Страница: 66 / 146

Page 58 FF7200 Operating Manual
Machining
DANGER
To avoid serious injury to hands or arms, do not reach inside
the swing of the turning arm during operation.
This type of machine has a hydraulic powered rotation with a pneumatic feed.
CAUTION
Using a different HPU than the one specified in this manual
will require a separate evaluation.
To operate, do the following:
1. Connect the energy sources.
2. On the HPU controller, turn the E
MERGENCY
S
TOP
button clockwise to reset the emergency stop.
3. Press the S
TART
button to start the HPU motor.
4. Press the S
PEED
C
ONTROL
S
LOWER
button until it is at the minimum.
5. Press the H
YDRAULIC
O
N
button.
6. Press the S
PEED
C
ONTROL
F
ASTER
button to reach the desired speed.
7. Turn the feed rate adjustment dial to the minimum feed or to the desired setting, if known.
8. Turn on the feed and adjust the feed rate for the desired cut.
9. Use the speed control buttons to adjust the drive motor to achieve the desired cut.
10. When the cut is complete, first stop the feed and then stop the machine rotation.
CAUTION
Recheck the chuck torque at intervals, including after
environmental changes (such as between night and day) in
case of thermal growth.
Adjusting the machine when the cut is completed
CAUTION
The cutting tools can get hot during machining. Wear
gloves or other protective personal protective equipment
and be careful of hot surfaces to avoid burns.