Climax FF7200, Руководство по эксплуатации

Страница: 59 / 146

P/N 59129, Rev. 9 Page 51
CAUTION
Be aware of all personnel near the machine when operating.
7. Turn on the spindle and verify the rotation direction of the cutter. If it is rotating the incorrect
direction, do the following:
a. Turn off the spindle.
b. Press the E-Stop button.
c. Lock out the HPU.
d. Switch hydraulic hoses either at the motor end or at the HPU to correct the
rotation.
e. Restart the spindle and verify the correct rotation direction of the cutter.
8. Move the machine axes to the desired starting location.
9. Advance the cutter to the desire cutting depth. Lock it in place.
10. Turn on the spindle and adjust the speed to the desired cutting rate.
11. Turn the feed to minimum.
12. Engage the feed and adjust the feed speed for the desired cut.
Adjusting the machine when the cut is complete
IMPORTANT
During milling operations, keep chips clear of moving parts.
Do not step on hoses or cables. Metal chips can be forced
through the cable jacket and damage cabling causing
machine malfunction and downtime.
When the cut is complete, do the following:
1. Reduce the feed speed to minimum and stop the feed.
2. Adjust the machine direction or depth of cut as needed.
3. Start the feed again and resume cutting until the desired milling area is completed.
When the milling is complete, do the following:
1. Stop the feed.
2. Retract from the work piece.
3. Stop the spindle
4. Press the E-stop.
CAUTION
Lock out the HPU before removing the cutter or
replacing inserts. Stopping the spindle while the feed
is running causes broken inserts.