Climax FF7200, Руководство по эксплуатации

Страница: 51 / 146

P/N 59129, Rev. 9 Page 43
Refer to Figure 30 while doing the following:
1. Lift the assembly using the lifting eyes.
2. Carefully lower the machine in between the vertical supports.
3. Position the machine onto workpiece. Use the jack screw legs while
positioning.
4. Adjust to approximate center and align the verticals radial to the machine
using the leveling and centering fasteners and tighten.
5. Adjust the machine parallel to the workpiece. Measure from the tool head to
the workpiece using a dial indicator.
6. Zero the indicators positioned over one set of legs, and then rotate 180º.
While monitoring the indicators you may adjust the machine using the leveling
legs. Make sure they are both moving in the appropriate direction evenly.
Move to the leg that is 90º from the first leg.
7. Repeat this process until you have achieved the desired alignment.
8. After all machine legs have been tightened, verify alignment before you
operate the machine. Check alignment periodically during machine operation.
9. Once you have achieved final alignment to the work piece, lock the assembly
into place, using the lock nuts on the outside legs, M36 screws and washers.
10. Install M16 screws into the top of the arm at the vertical supports.
11. Check that all fasteners are tight.
Figure 30. Fixture and vertical assembly