Climax BB7100, Руководство по эксплуатации

Страница: 20 / 130

Page 12 BB7100 Operating Manual
Boring Bar and Bearing Support Setup
At least two bearing support assemblies are required to ensure machine stability. The bearing
assemblies may be different styles.
CAUTION
At least two bearing supports are required to ensure
machine stability. The bearing assemblies may be different
styles. Bearing supports placed too far apart allow the bar to
deflect, reducing bore precision.
Clamp Collars
P/N 42792 – The collars are made in matching sets and must be used to secure the bar when
the machine is in the vertical orientation.
This will prevent the bar from sliding through the support bearings or falling.
To prevent over tightening of the bearings, the clamp collars should be placed above at least
two support bearings in a vertical orientation.
DANGER
To prevent the bar from sliding through the
support bearings, or falling, use the 2 clamp
collars provided in the tool kit when using the
boring bar in a vertical orientation. Torque to 46 ft.-
lbs!
End-mount bearing support setup
Even though the end-mount bearing support attaches to the outside of the work piece, it can
be placed anywhere along the boring bar. During setup, the bearings can have as much as 1
degree of angle in the + or – direction.
4. Clean the bore of the work piece with solvent to remove grease, oil, and dirt.
5. Check the bar for nicks or cuts. Dress the bar smooth, if necessary. A bar with nicks
or gouges can damage mating parts beyond repair (including the axial tool carrier and
rotational drive unit).
6. Clean the bar with solvent to remove dirt and chips.
CAUTION
The bar is not hardened. To prevent bar damage, do not
strike the bar against the bearing supports or against the
work piece.