Optional Trunk Trigger Connection
The switch may be located in or near the trunk latch or at the trunk light. Otherwise you
may install a pin switch in a location away from water channels.
1. Connect the GRAY/YELLOW wire to the negative-switching trunk pin switch.
Auxiliary A Output
The Auxiliary A output (GRAY/VIOLET wire) is activated by pressing the
✱
or
Opt
button
on the remote control. This output is preprogrammed to operate only when the system is
disarmed (e.g., for use as a remote trunk release). It can also be used as the secondary unlock
line if wiring the door locks for 2-stage unlocking (see the previous
Door Locks
section).
The factory setting is pulsed output (1 second ground). Interlock is on (operates only if the
system is disarmed and the ignition is off). Current is limited to 0.15 amp.
After power-up, see
Installer-Programmable Features
on page 10 to change the type of output
and/or turn the trunk interlock off or on.
Auxiliary B Output & Selectable AutoActivation
The Auxiliary B output (GRAY/BLUE wire) is activated by pressing the
✱
+
button
combination (or
Opt+ LOCK
button combination) on the remote control. This output can
be programmed as either pulsed, latched or timed, and can also be programmed to operate
only when the system is disarmed (e.g., for use as a remote trunk release).
The factory setting is pulsed output (1 second ground). Interlock is off (operates regardless of
system or ignition state). Current is limited to 0.15 amp.
You can also set this output to automatically activate every time the system is remotely armed
(perfect for vehicles with a window/sunroof all-close feature; see below). After power-up, see
Installer-Programmable Features
on page 10 to change the type of output, set AutoActivation
and/or turn the interlock on or off.
European Vehicle Window/Sunroof All-Close
If turning and holding the door key closes the power windows/sunroof (a common feature on
European vehicles), you can make them close upon automatically remote arming:
1. Find the wire that shows +12V or ground when the key is held to lock in the door cylinder.
2. Tap a wire in to this wire and connect to terminal 30 of a relay.
3. If the wire shows ground when the key is turned, connect terminal 87 to ground; if +12V,
connect terminal 87 to 12V.
4. Connect the GRAY/BLUE wire to terminal 85.
5. Connect terminal 86 to +12V.
6. Set the Auxiliary B output to use the timer and to AutoActivate.
7. Set the Accessory Output Timer to 2 seconds longer than the total time it takes to close
all windows/sunroof.
Remote Timed Headlight Activation/Automatic Post-Parking Illumination
You can make the following connections to provide remote timed headlight activation and/or
automatic timed post-parking illumination upon remote arming. Simply follow the steps
above using the wire that shows +12V or ground when the headlight switch is activated. If
you set the output to AutoActivate, the headlights will turn on and stay on for the
programmed duration every time the vehicle is armed.
6
8
D:...-922 Level 4 install manual.vp
Wed Aug 04 17:37:16 1999
Color profile: Disabled
Composite Default screen
